StudioLive 16.4.2 AI (Recently bought second-hand in very clean condition)
Note: The problems below were there before and after firmware restore.
Running the latest firmware, also did a factory defaults firmware restore. (The “crude” method i.e. removing the I/O board first)
Problem 1: All the rotary encoders are not precise. Turning them up slow (clockwise) will change nothing (fat channel) They will react turning them faster. Note: Turning them down slow (counter-clockwise) is noticeably better but still not great.
Problem2: The mixer today did power-up with ALL previous settings at defaults!? I quickly notices because LCD brightness/contrast was reset. The rest of the system settings were also at default. (Peak-hold, sample frequency etc) This happend after the mixer was powered-off for less than 12 hours.
One other strange thing: All 50 channel presets are there after restore but ALL have the prefix DRM, no GTR or VOX whatsoever.
I’ve run out of options….Thanks in advance for anyone willing to shine a light on this subject.
Users browsing this forum: No registered users and 5 guests