Temblor T10 and Temblor T8
3 posts
Page 1 of 1
Hi There,

I have a couple of Eris E5s connected to a Tremblor T8. How do you disable the noise gate on these speakers, it's truly mind-numbing sorry!

I've searched for this but am obviously using the wrong search terms so sorry if this is easy.

Cheers

- FAIRLY NEW TO S1, MIGRATED FROM LOGIC
- STUDIO ONE PRO 5.3.0.65413
- FOCUSRITE CLARETT 8 Pre
- OSX 11.4, MACBOOK PRO 16,4, 64GB RAM, 2TB INTERNAL SSD
User avatar
by andrewpeplinski on Fri Mar 12, 2021 10:45 am
Hey, Ben67 - the Temblor has a standby feature, which kicks in if it doesn't see enough signal; I play music at a very low volume, and it tends to cut off a lot.

In all my searching, the only "solution" I found seriously risks frying the whole unit and completely voids the warranty (it involves soldering a couple of pins on the relay that controls that threshold).
User avatar
by ben67 on Fri Mar 12, 2021 12:32 pm
Thanks for the reply, much appreciated.

- FAIRLY NEW TO S1, MIGRATED FROM LOGIC
- STUDIO ONE PRO 5.3.0.65413
- FOCUSRITE CLARETT 8 Pre
- OSX 11.4, MACBOOK PRO 16,4, 64GB RAM, 2TB INTERNAL SSD

3 posts
Page 1 of 1

Who is online

Users browsing this forum: No registered users and 0 guests