I just bought a 192 and ran into the following issue:
I use Studio One 4 Professional, and a Metric Halo ULN-2. The ULN-2 is connected to the 192's SPDIF I/O to use a mic preamp and A/D converter (I think it sounds tad better in the highs than the 192's converter).
The setup basically works fine, but when I enable hardware monitoring in Studio One, no input or output is routed through the ULN-2.
Is there any way I can use hardware monitoring and use the ULN-2 at the same time?
Users browsing this forum: No registered users and 2 guests