StudioLive 2442, 1642 and 1602 with Universal Control Ai, SL Remote & QMix
1 post
Page 1 of 1
Hey,
im using UC v1.7.6 and my current firmware is 1.13.
When I start UC it says I have to make an firmware update.
Its starts and then said there was a problem and I have to reconnect and do it again...but this comes again and again. Same when I want to make an factory reset.

Im using an Logilink PC0030A Firewire card (With a via Chip VT6330, thats on the approved FireWire list)

My system is attached.

Hope you can help me!

No one? Anyone?

Attachments
specs.JPG

1 post
Page 1 of 1

Who is online

Users browsing this forum: No registered users and 3 guests