Page 1 of 1

+4dBu or -10dBV on the Quantum 4848?

Posted: Sat Nov 09, 2019 9:27 am
by tomdepoorter
I've seen a couple of youtube clips where they mention there's a possibility to switch between +4dBu (pro) and -10dBV (consumer) line level on the Quantum 4848 - which I just purchased. I presume this had to be switched in Universal Control but can't seem to find anything.

Can anyone help point out the right direction? Thanks!

Re: +4dBu or -10dBV on the Quantum 4848?

Posted: Sat Nov 09, 2019 11:17 am
by frank.crow
If I’m not mistaken it is +4dBu by default but clicking the-10 on universal control changes it to-10dBu

Re: +4dBu or -10dBV on the Quantum 4848?

Posted: Sun Nov 10, 2019 12:52 pm
by tomdepoorter
Thanks for the answer Frank. But I can't seem to find a button in Universal Control to change to -10. Any ideas where to look?

Re: +4dBu or -10dBV on the Quantum 4848?

Posted: Mon Nov 11, 2019 10:07 am
by frank.crow
tomdepoorter wroteThanks for the answer Frank. But I can't seem to find a button in Universal Control to change to -10. Any ideas where to look?


When Universal Control opens click on the image of the Quantum Interface
The next screen will show you all of your available
Inputs/Outputs

Channels 3 onwards have a little box above each knob that says -10dBV
It’s dim because it’s not activated so the channel is defaulting to +4dBV