Hello forum
I recently bought a Studio 1810c and I am a long time user of a Studio 192. I noticed an issue with the latest UC Control versions. When I was using with Studio 192 I used to run the interface on 2048 Block size and dropout protection at minimum in S1. The Studio 192 was working fine

While running the latest UC Control (Universal Control 3.6.1.84519 Win x64 (Built on Nov 23 2021)
I tried the same setup on 1810c with Block size 2048 and dropout protection at minimum in S1 and I have cracks and pops.

I had to change is to the following settings using the Studio 1810c
Block size 64
Dropout Protection Maximum
No cracks and pops

Is this correct ? Is this by design ?

Thanks a lot