Discuss the new Studio 192 and Studio 192 Mobile here
2 posts
Page 1 of 1
I have a feedback loop between my inputs and outputs of my Studio 192. When I plug a TS cable from an output into an input of the interface, audio from the input is being fed back into the output, causing a maxed-out level on my input channel.

It may seem odd for me to test this; however, any external FX I add to my setup has a very hot, maxed-out level as soon as I complete the audio signal path (i.e. output of interface into input of external FX and output of external FX into input of interface).

My guess is that some funky routing is happening in Universal Control.

Thanks in advance for any help!
User avatar
by florentherbinger on Sun Feb 21, 2021 8:37 am
I was finally able to solve the issue by bypassing the mixer in Universal Control; I had done this a while back but did not realize that the output numbers are bumped up by 2, which made me think that no audio was being outputted in bypass mode.

2 posts
Page 1 of 1

Who is online

Users browsing this forum: No registered users and 1 guest