Studio 192 and UC Surface Won't Start Up
Posted: Fri Jun 24, 2016 5:48 am
System I am using
Windows 7
Intel I-7 3.5Ghz
16Gb Ram
3.0 USB
Running latest version of Studio One 3 (updated yesterday)
Dedicated to my home studio no other programs run on this computer
I purchased my 192 from Sweetwater a few days ago and had the opportunity to try and get underway last evening. Prior I was using my original 22vsl.
Got everything together and kept getting the following message every time I tried to open Studio One
Failed to start correctly would you like to retry. (I did a few times but realized that I wasn't going to get anywhere)
Subsequent message was that Studio 192 could not be initialized to check hardware configuration and try again. I tried to open S192 from the configuration screen and got the same messages.
I did get it to connect on one occasion and I thought I was out of the woods and then I got the message to update the firmware on the UC Surface which I attempted to do. A little way into that process I got an 'error 2010' message that the update had failed. I did after numerous other attempts have the UC Surface look as if it was going to allow me to update the firmware again when I tried I got the same result the 'error 2010'.
I consulted the forum last night and saw where a suggestion was made to move to 2.0 USB and I tried that too and no luck.
Just so you know I've tried, I have turned off, unplugged and replugged, rebooted (numerous times), so those basic resets have been tried.
Advice anyone? I was like a kid in the candy store putting back some cash to get this new interface and I am so frustrated. Like most I have a project I'm in the middle of and really need to keep moving.
Thanks.
Windows 7
Intel I-7 3.5Ghz
16Gb Ram
3.0 USB
Running latest version of Studio One 3 (updated yesterday)
Dedicated to my home studio no other programs run on this computer
I purchased my 192 from Sweetwater a few days ago and had the opportunity to try and get underway last evening. Prior I was using my original 22vsl.
Got everything together and kept getting the following message every time I tried to open Studio One
Failed to start correctly would you like to retry. (I did a few times but realized that I wasn't going to get anywhere)
Subsequent message was that Studio 192 could not be initialized to check hardware configuration and try again. I tried to open S192 from the configuration screen and got the same messages.
I did get it to connect on one occasion and I thought I was out of the woods and then I got the message to update the firmware on the UC Surface which I attempted to do. A little way into that process I got an 'error 2010' message that the update had failed. I did after numerous other attempts have the UC Surface look as if it was going to allow me to update the firmware again when I tried I got the same result the 'error 2010'.
I consulted the forum last night and saw where a suggestion was made to move to 2.0 USB and I tried that too and no luck.
Just so you know I've tried, I have turned off, unplugged and replugged, rebooted (numerous times), so those basic resets have been tried.
Advice anyone? I was like a kid in the candy store putting back some cash to get this new interface and I am so frustrated. Like most I have a project I'm in the middle of and really need to keep moving.
Thanks.