Discuss the new Studio 192 and Studio 192 Mobile here
1 post
Page 1 of 1
I just bought a 192 and ran into the following issue:

I use Studio One 4 Professional, and a Metric Halo ULN-2. The ULN-2 is connected to the 192's SPDIF I/O to use a mic preamp and A/D converter (I think it sounds tad better in the highs than the 192's converter).

The setup basically works fine, but when I enable hardware monitoring in Studio One, no input or output is routed through the ULN-2.

Is there any way I can use hardware monitoring and use the ULN-2 at the same time?

1 post
Page 1 of 1

Who is online

Users browsing this forum: No registered users and 1 guest