Width of a measure
Posted: Mon Dec 31, 2018 5:03 pm
Is the a way of setting the width of a single measure.? I have section of my piece ending on a single measure. The other measures are nicely spaced so I would like to leave them that way. If I force a new system the measure the single measure stretches across the page.
I can leave it at a narrow width by putting a double bar line at the end of the measure, then deleting the extra bars. Then I can’t start a new system.
This works the same way in print view.
Of course I can work around this by adjusting measures per system, and notation font.
I can leave it at a narrow width by putting a double bar line at the end of the measure, then deleting the extra bars. Then I can’t start a new system.
This works the same way in print view.
Of course I can work around this by adjusting measures per system, and notation font.