2 posts
Page 1 of 1
Hear is the deal. I have Firestudio Project, Studio One 2 Pro and an Art Headamp 4.

the Art Headamp 4 connects using one TRS Cable. i have a two band trs cable for lack of better terms (cable with 2 black bands on 1/4 connecter) and it plays stereo just fine when I had it connected directly to my headphone output in the front of the firestuduo project.

What I want to be able to do is connect the Art Headamp to one of the outputs in the back so that I can connect my mixing headphones directly to the headphone output in the front..

Does anyone know how I would go about doing that?
How do I send a signal out of one of one of the outputs in the back to where it will play stereo through my headamp. I have tried a couple of different settings and sending it through output 3 in the back and all it plays is the left side even I set the send signal up for mono...

Any advice?
User avatar
by mwright137 on Thu Jul 03, 2014 5:03 pm
I have a HeadAmp Pro 6 and there are stereo direct inputs. I have a insert cable (TRS to two TS) and I plug the two TS ends into outputs 1 and 2 on my FireStudio Project and then the TRS and into the direct input on the ART. Instant stereo mix...

I am Sir Melvis Bacon, Knight of BaconHam Palace.

Studio One 2 Pro 3.3.x (64 bit). MacBook Pro 13". OS X Sierra version 10.12.3.
RM16AI and CS18AI connected in Stagebox mode via MOTU AVB Switch.
StudioLive 328AI (x2); AudioBox 22 VSL; BlueTube DP V2; FaderPort; Monitor Station; RC 500; Temblor T10.

To add your software and hardware specs to your signature to make it easier for us to help you, click HERE.

My Website

2 posts
Page 1 of 1

Who is online

Users browsing this forum: No registered users and 4 guests