1 post
Page 1 of 1
I noticed something about the way S1 implements keyswitches.

This is what a guitar part looks like to start with:


Just a few short keyswitches.

Sounds like this:
(221.73 KiB) Downloaded 22 times

But if I setup the keyswitches it looks like this:


This make the keyswitches sound until the next switch.
Hear the difference:
(221.73 KiB) Downloaded 14 times

I found I could make a new keyswitch called Stop that calls an unused key like C-1:

After doing that it sounds like the first one, back like it should sound.

Nice if there was a way to switch that behavior on and off.

Forum Moderator.
Please add your specs to your SIGNATURE.
Search the STUDIO ONE 5 ONLINE MANUAL. Access your MY.PRESONUS account.
OVERVIEW of how to get your issue fixed or the steps to create a SUPPORT TICKET.
Needs to include: 1) One Sentence Description 2) Expected Results 3) Actual Results 4) Steps to Reproduce.

Studio OnePro5.1 64bit Melodyne Studio
Studio Computer - Nectar Impact LX25+
Win10 i7 7700k 16gb ram 1TB SSD AsusH270M-PLUS interface:StudioKonnekt 48
Kitchen Computer - Microkey Air
Win10 Ryzen 5 3600 - Radeon RX 590 - 16GB DDR4 3000MHz - 512GB SSD interface: Motu M2

1 post
Page 1 of 1

Who is online

Users browsing this forum: No registered users and 64 guests